Thermo Electron 8600 Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 33 / 74

6.2 Chart Recorder
a. Installing the chart paper
1. Open the glass door of the recorder and press button #3 until
the pen begins to move outward.
2. Unscrew the knob at the center of the chart and remove the
paper.
3. Install the new chart paper, position the paper to the correct
time line and replace the knob.
4. Remove the cap from the felt pen and press button #3.
b. Recorder Calibration
Changing the recorder range:
The chart recorder contains eight temperature ranges and is
factory-programmed for the freezer.
1. Press and hold button #3 for one second, then let the pen
move off the chart paper.
2. Press and hold for five seconds either button #1 or button #2.
3. Release the button and the green LED will begin to flash.
Count the number of flashes to determine the present program
setting.
4. To change the program setting, press the left or right arrows to
increase or decrease the count.
5. When the desired program number is flashing, press button #3
to bring the pen arm back onto the chart. Recording will
begin in the new program.
Calibrating the chart recorder:
The recorder must be in service for 24 hours before per-
forming the following calibration procedure.
1. Place an accurate thermometer in the chamber next to the
recorder probe.
2. Temperature probes for the recorder are located in the left
front corner of the freezer chamber (Figure 1-4).
3. After about three minutes, compare the thermometer reading
with the chart recorder reading.
4. If an adjustment is necessary, press the #1 button to move the
pen to the left or the #2 to move the pen to the right. The but-
ton must be held about five seconds before the pen begins to
move. Release the button when the pen position matches the
thermometer.
NOTE: The felt-tip pen on the recorder requires periodic
replacement. Usually the ink will appear to fade before
replacement becomes necessary. Additional pen tips
may be purchased. Refer to Parts List, Section 8.
Figure 6-8
Recorder Buttons
Program From To
1 -40 30°C
2 0 60°C
3 -100 38°C
4 -5 50°C
5 0 100°C
6 -100 200°C
7 -115 50°C
8 -10 70°C
6 - 4
8600 Series ______________________________________________________________________________Factory Options
Figure 6-7
Recorder Details