background image

4

ENGLISH

USER

PRECAUTIONS

GENERAL SAFETY INFORMATION

Do not allow children or 
infirm persons to operate 
the boiler unsupervised. 

Do not operate any electrical 
devices or equipment, includ-
ing switches or domestic appli-
ances, etc., if you can smell fuel or 
fumes. If you detect any suspicious smells: 

  - Ventilate the room by opening all doors and win-

dows. 

  - Close the fuel shut-off cock. 
  - Report the fault immediately to 

THERMITAL

’s 

Technical Assistance Service or a professionally 
qualified heating engineer. 

Never clean or service the boiler without first discon-
necting it from the mains electricity supply by turning 
the main power switch OFF. 

Never pull, disconnect, or twist the electrical cables 
coming from the boiler even if it is disconnected 
from the mains electricity supply at the time. 

Do no obstruct or restrict the vents in the room 
where the boiler is installed. Adequate ventilation is 
essential for correct combustion. 

Do not store containers of flammable substances in 
the room where the boiler is installed. 

Do not touch the boiler when 
barefoot or wet. 

Do not switch the boiler off 
if outside temperature drops 
below ZERO (risk of freez-
ing). 

This instruction manual and that for the installer 
and Technical Assistance Service are integral parts 
of the boiler. They must be kept safe and must 
ALWAYS accompany the boiler, even if it is sold 
to another owner or user or transferred to anoth-
er installation. If you damage or lose this manual, 
order a replacement immediately from your local 

THERMITAL

 Technical Assistance Centre. 

This boiler must be installed by a 
legally qualified heating engi-
neer (in Italy heating engi-
neers are regulated by law 46 
of the 5th March 1990.) On 
completion of the installation, 
the heating engineer must 
issue the owner with a decla-
ration of conformity confirming 
that the installation has been com-
pleted to the highest standards in compliance with the 
instructions provided by 

THERMITAL

 in this instruc-

tion manual, and that it conforms to all applicable laws 
and standards. 

If you notice any water leaking from the boiler, dis-
connect it immediately from the mains electricity 
supply, shut off the water supply, and notify your 
local 

THERMITAL

 Technical Assistance Centre or a 

qualified heating engineer immediately. 

Periodically check that oper-
ating pressure in the water 
circuit is 

over 1 bar

. If water 

pressure is consistently 
low, contact 

THERMITAL

’s 

Technical Assistance Service 
or a professionally qualified 
heating engineer. 

If the boiler is not going to be used for an extended 
period of time, proceed as follows to prepare it for 
shutdown.

 

-  Turn the mains power switch OFF. 

 

-  Close the boiler’s fuel cock and water cock. 

 - 

Drain the central heating circuit if there is any risk

 

  of freezing. 

The boiler must only be used for the purpose spec-
ified by 

THERMITAL

 and for which it is designed. 

The manufacturer declines all responsibility, con-
tractual or other, for damage to property or injury to 
persons or animals caused by improper installation, 
adjustment, maintenance or use. 

The operation of any appliance that uses fuel, electrical power and water demands that a number of fundamental safe-
ty precautions be respected. 

Содержание SUNDAY 200 SOL

















Отзывы: