THERMEx Wasteminator III, Руководство пользователя

Страница: 6 / 16

2.Check the installation size
1. Disposer's height( 1 )
2. The bottom of sink to the middle of discharging
mouth（If not stainless steel sink you are using, please
add extra 12mm to this height.）( 2 )
3. Disposer's width( 4 )
4. Disposer's vertical center line to the vertical center
line of "U" pipe.( 5 )
In order to drain off water properly, the outlet pipe (into the wall) shall located lower
than the disposer unit.
3.Disconnect Sink Drain
1. Loosen nut at the top of trap with pipe wrench.
2. Loosen nut at the top of extension pipe. Remove extension pipe.
3. Loosen nut at base of sink flange.
4. Push sink flange up through sink hole and remove it.
5. Cleank sink flange area of any putty or other debris.
Note：If the sink hole is suitable for the food waste disposer, please purchase
the same sized sink from local dealer.
4.Disassemble New Disposer Mounting Assembly
B/D Series stainless steel clamp ring
1-1. Turn mounting assembly over and loosen three mounting screws until you can
access snap ring.
1-2. Use screwdriver to pry snap ring (1) off of the sink flange。 Mounting assembly
will now come apart. （Picture 4.1）
B/D Series rubber clamp ring
2-1. Unlock the lock catch of the snap ring, take off the snap ring.
2-2. Take off the sink flange.
C Series Mounting Assembly
3-1. Insert four vibration suction cups （1） into the bottom of the disposer.
（ Picture 4.2）
3-2. Cut the connection hose properly according to the distance between sink
bottom to the cabinet bottom.（Cut part 1）（Note：Make sure the incision is even).
Insert glange nut into connecting hose, and then put the clamp onto the hose,
connect the hose with the disposer, lock the clamp screw tight. （Picture 4.3）
1
2
3
4
5
6
7
9
10
13
14
15
16
（picture 1.3）
D series installation parts（picture 1.3）
8
11
12
（Picture4.1） （Picture4.2） （Picture4.3）
1
3
1
04 03
2
1
1
4
5
（图2.1）
3
2
Food Waste Disposer Users’ Manual Food Waste Disposer Users’ Manual
Installation parts disposer discharging parts
1. Filter and splash guard
2. Sink flange
3. Rubber gasket
4. Fiber lining
5. Support ring
6. Mount ring
7. screw（3）
8. Snap ring
9. Tension spring
10. Sealing gasket/splash
guard 11. propeller
12.dishwasher water inlet 13. Rubber seal
14. Bend pipe flange
15. hexagon socket screw
16. Discharge bending pipe