THERMEx WASTEMINATOR II, Инструкция по монтажу

Страница: 61 / 74

M 780672000203022015
THERMEX
WASTEMINATOR
61
EN
GL
IS
H
»
W
ARNINGS
• The product is designed and manufactu-
red according to DS/EN 60335-1.
• This product is only for use in private
households, if used for other purposes the
warranty will be repealed.
• Installation must be performed by a skilled
electrician in accordance with the
specifications given by Thermex Scandina-
via A/S (Thermex) and legislation in force.
• Thermex disclaims all responsibility with
regards to damages caused by wrong
installation, mounting or use.
BEFORE MOUNTING/COMMISSIONING
•
Inspect the product for transport
damages, flaws and defects immediately
after the receipt.
• Transport damages must be filed to the
haulage contractor and Thermex
immediately after the receipt.
• Flaws and defects must be filed to
Thermex within 8 days after the receipt,
and not later than mounting/commissio-
ning.
INSTALLATION
•
Always read these instructions carefully
BEFORE beginning installation of the
Wasteminator II.
• Remember to apply to your local
authorities for a permit to install a
waste grinder.
• The device is designed to operate at 230
volts ± 10% ~ 50 Hz ± 15% according to
EN 50160
• Connect Wasteminator II to the power
supply with the supplied Schuko plug.
• Wasteminator II must be earthed ( )
• Do not connect Wasteminator II to the
power supply until after installation.
• Install the drain trap on the drain after
the Wasteminator II to avoid odours.
• The pipes for the dishwasher and
overflow from the sink must be closed if
not used, otherwise water will drain out
when Wasteminator II is in use.
• Install rubber gaskets in all joints on the
drain to ensure that the drain closes
tightly.
• Be sure to remove all items from inside
Wasteminator II prior to installation.
• It is recommended that the sink in which
Wasteminator II is fitted has a notch
that fits with the flange of the
Wasteminator so that the flange is flush
with the bottom of the sink.
WARNINGS