THERMEx Mini Bordeaux, Инструкция по монтажу

Страница: 58 / 68

58 THERMEX Mini Perpignan & Mini Bordeaux M 540231481222122020
Engl
Is
H
»
INS
TALL
ATION
INSTALLATION
The range hood is available either with an internal motor or for installation with an external motor.
Measure out and mark the two “keyholes” on
the wall. NOTE: For a rear-facing exhaust
outlet, the holes are marked out in relation to
the exhaust outlet’s position on wall Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes. NOTE: The screws must not be screwed in
further than the hood can be installed.
x2
x2
x2
Hang the hood on the screws. Open the glass
door and remove the filter. Mark the position of the two lock-holes on the
wall and then remove the hood from the wall
once again. Pre-drill the holes and insert the rawlplugs.
x2
x2
Re-hang the hood.
NOTE: For a rear-facing exhaust outlet, the
exhaust outlet should be installed on the hood
in this step. Reinstal the filter in the hood and close the
glass door. Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air and with the exhaust outlet facing
upwards.
8
x2
1
2
3
4
5
6
7
9