THERMEx AIRGRIP, Инструкция по эксплуатации

Страница: 29 / 36

B 530265000206052015
THERMEX
AIRGRIP
29
• The range hood is designed and
manufactured according to DS/EN
60335-1.
• This range hood is only for use in private
householdings, if used for other purposes
the warranty will be repealed.
• Installation must be performed by a skilled
electrician in accordance with the
specifications given by Thermex Scandina-
via A/S (Thermex) and legislation in force.
• Thermex disclaims all responsibility in
regards to damages caused by wrong
installation, mounting or use.
BEFORE MOUNTING/COMMISSIONING
•
Inspect the range hoodfor transport
damages, flaws and defects immediately
after the receipt.
• Transport damages must be filed to the
haulage contractor and Thermex
immediately after the receipt.
• Flaws and defects must be filed to
Thermex within 8 days the receipt, and not
later than mounting/commissioning.
MONTERING
• The range hood is intended for working at
230 Volt ±10%~ 50 HZ ±10% in referring to
EN 50160.
• The range hood must have earth.
• For models with external motor applies
that NOT to use common zero by instal-
ling the hood and engine, as this will af-
fect the control.
• Do not plug in the range hood until the
mounting is complete.
• Always use the original dimension of the
vent. By reducing the dimension of the
vent, the performance will be reduced and
the sound level will be increased.
• The vent to the open air, must be as short
as possible in order to get the greatest
possible capacity of the range hood.
• The number of bends on the vent ought to
be minimesed, to gain the greatest
possible capacity of the range hood.
• Thermex recommends to always use
sound and condensation insulated vent
hose at the carrying through in unheated
spaces.
• Thermex recommends that there is used
for a muffler to minimize the noise level
when using flexible hose.
• Using the flexible hose must always en-
sure that this is fully extended to mini-
mize air resistance and thereby achieve
maximum absorbency.
• Different materials takes different
rawlplugs and screws. Use rawlplugs and
screws intented for the material the range
hood is to be mounted in.
• It is applied to cabinet range hoods, islands
and wall mounted range hoods that the
minimum space between the lower edge of
the range hood and a gas cooker must be
50 cm in referring to BEK No. 420 of
EN
GL
SIH
»
W
ARNINGS
WARNINGS