Thermann 16LP50, Руководство по установке

Страница: 12 / 20

12 INSTALLATION INSTRUCTIONS
REMOTE CONTROLLERS
4. INSTALLATION OF MAIN CONTROLLER
Safety precautions
• Connect remote controller cable after heater is unplugged.
• Never install Main remote controller above a combustion appliance like hot plate or a
kitchen range. The heat will cause electrical component problems, or deform the exterior.
• Install Main remote controller where it will not be subjected to splashing water or steam
from appliances.
• Do not install Main remote controller in direct sunlight.
• Do not install Main remote controller where any commercial chemicals such
as ammonia, sulfur, chlorine, ethylenic compound and acids etc are used.
• The remote controller cables carry low voltage, 12VDC.
Installation
• Install conduit inside of wall in advance. Alternatively conceal wires inside wall cavity.
• Pass remote controller cables through conduit/wall cavity. Then pass the cables
through the hole of the fitting bracket and pull them out.
• Attach the fitting bracket with screws.
• Connect the remote controller cables to the terminal on the rear of the controller.
• Fit controller to fitting bracket and secure.
Screw
Remote controller
fitting bracket
Hole for wiring
Cover
Cover
Screw
Detach right-and-left covers of the remote controller and fix them to the wall directly with screws.
Then attach the covers again.
Chemicals
Do Not