User's Manual
VB6000B Series - Swing
7
8
On the front of the case, you can find some
LEDs and switch leads (SPEAKER*1, POWER
SW*1, POWER LED*1, H.D.D. LED*1, RESET
SW*1). Please consult user manual of your
motherboard manufacturer, then connect these
leads to the panel header on the motherboard.
These leads are usually labeled; if not, please
trace them back to the case front to find out
their source.
3.2 Case LED connections
-
POWER LED
connects to your M/B at the PLED
-
POWER SW
connects to the PWR connector on
the motherboard.
-
SPEAKER
connector: find out the 4-pin labeled
SPEAKER on the M/B then connect it.
-
H.D.D LED
connects to the 2-pin labeled HDD
LED connector.
RESET SW connects to the RSW connector on
the motherboard.
There are four wires with different
connectors inside the case, these are
shown as follow:
USB1(4+1pin),
USB2(4+1pin),
IEEE1394,
front Audio connector
USB2.0 connection: it is compatible
for USB1.1
Please consult your motherboard manual to find
out the position of USB 2.0 connection on your
motherboard. You can see 10-pins in two rows.
- USB1 includes VCC1, USB1-, USB1+,
GND1, GND.
- USB2 includes VCC2, USB2-, USB2+,
GND2, GND.
Connect "2.0 USB1" to the one of two rows on
the motherboard.
Connect "2.0 USB2" to the other row.
3.3 USB 2.0 & IEEE 1394 firewire connections
Note:
One or two pins may be shown in both rows as NC on some motherboards,
please ignore it, NC means empty pin
USB 1
IEEE1394
USB 1
(Support USB 2.0))
MIC
EAR