Thermaltake DH 101, Руководство пользователя, Страница: 11 / 25

Each motherboard has different standoff layout. It is highly
suggested that you refer to your motherboard's manual when installing
motherboard into the case. The cases are applicable with Standard
ATX, Micro ATX motherboards. Your motherboard may require a
special I/O Panel, which should be included with your motherboard.
Placement Direction:
When installing the motherboard, make sure you follow the direction
provided by your motherboard manufacturer. On most standard
motherboards, the edge with external ports goes to the rear part of
the chassis. It is highly recommended that you install CPU, heat
sink and modular components before fixing the motherboard inside
the chassis.
= the locations of
the screw holes. Note
these locations and
place included
standoffs on the chassis
first.
This side towards
the rear of the
chassis
Above illustration is a sample of what the
motherboard's layout. For more detail screw
hole placement, please refer to your mother
board manual.
Chapter3 Motherboard & Leads Installation Chapter3 Motherboard & Leads Installation
3.1 Motherboard Installation
On the front of the case, you can find some LEDs and switch
leads (POWER SW*1, POWER LED*1, H.D.D. LED*1,
RESET SW*1, SPEAKER*1).
Please consult user manual of your motherboard manufacturer,
then connect these leads to the panel header on the
motherboard. These leads are usually labeled; if not, please
trace them back to the case front to find out their source.
- POWER LED
connects to your M/B at the PLED.
- POWER SW
connects to the PWR connector on the motherboard.
-
H.D.D LED
connects to the 2-pin labeled HDD LED connector.
-
RESET SW
connects to the RSW connector on the motherboard.
-
SPEAKER
connector: find out the 4-pin labeled SPEAKER on the M/B
then connect it.
3.2 Case LED connections
8
9