Thermal Solutions AMP 1000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 54 / 88

54
NOTICE NOTICE
1. These are suggested piping configurations. It is the installer's responsibility to
conform to local codes and ordinances for additional requirements.
2. Pressure relief valve rating shall not exceed pressure rating of any component
in the system.
3. Some piping components cannot be supported by the pipping. Refer to the
manufactures' installation instructions.
4. Circulation pump must be sized to overcome the pressure drop across the entire
loop.
!
System Circulator
Hot Water Return
Factory Supplied Manifold
Check Valve
Water Heater Circulator
Y-Strainer
Isolation Valve
Storage Tank
Thermometer
Mixing Valve
Cold Water Supply
Hot Water Supply
Exansion Tank
T&P Relief Valve
Recirculation Filter
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Pressure relief valves shall not exceed the pressure
rating of any components in the system.
3. The circulator shall be sized to overcome the
pressure drop across the entire loop.
5/28/2019
AMP Water Heater Piping with Tank
Figure 23: Single Appliance, Single Tank
XI . Hot Water Supply Boiler Piping
(continued)