Thermal Dynamics CutMaster 75, Руководство по эксплуатации

Страница: 33 / 48

Manual 0-2868 5-5 SERVICE
3. Air flow obstructed (TEMP indicator ON)
a. Check for obstructed air flow around the unit
and correct condition.
4. Gas pressure too low (GAS indicator OFF when
torch switch is activated)
a. Check source for at 70 psi (4.8 bar); adjust as
needed.
5. Faulty components in unit
a. Return for repair or have qualified technician
repair per Service Manual.
I. No gas flow; AC POWER indicator ON; Fans
operate
1. Gas not connected or pressure too low
a. Check source for at least 70 psi (4.8 bar).
2. Gas supply pressure too high
a. Maximum 125 psi (8.6 bar) inlet pressure
3. Shield Cup not properly installed.
a. Check that Control Circuit (PIP) pins are in-
stalled. Refer to the torch manual for details.
4. Faulty components in unit
a. Return for repair or have qualified technician
repair per Service Manual.
J. Torch cuts but not adequately
1. Current control (A) set too low
a. Increase current setting.
2. Torch is being moved too fast across workpiece
a. Reduce cutting speed (refer to Torch Instruction
Manual supplied with torch).
3. Excessive oil or moisture in torch
a. Hold torch 1/8 inch (3 mm) from clean surface
while purging and observe oil or moisture
buildup (do not activate torch).
4. Torch tip being dragged on work.
a. Lift torch tip off work. At output settings over
40 amps, the power supply automatically re-
duces output current to 40 amps if the torch tip
contacts the workpiece.
5.05 Power Supply Basic Parts
Replacement
WARNING
Disconnect primary power to the system before dis-
assembling the torch, leads, or power supply.
This section describes procedures for basic parts replace-
ment. For more detailed parts replacement procedures,
refer to the Power Supply Service Manual.
A. Cover Removal
1. Remove the upper screws which secure the cover
to the main assembly.
NOTE
There is a ground wire connection to the inside of
the unit. There is no need to disconnect the ground
wire, unless there is a need for more room to work.
A-03001
Lower
screws
Upper screws
Ground wire
Lower
screws
Upper
screws
Cover Removal