40
WARNING
Disengage the drive roll when testing for gas flow by ear.
Inconsistent Wire Feed
Checking the following points can reduce wire-feeding problems:
1.
Wire spool brake is too tight.
Feed roller driven by motor in the cabinet will slip.
2.
Wire spool brake is too loose.
Wire spool can unwind and tangle.
3.
Worn or incorrect feed roller size.
Use 'U' groove drive feed roller matched to the
aluminium wire size you are welding.
Use 'V' groove drive feed roller matched to the steel
wire size you are welding.
Use ‘knurled V’ groove drive feed roller matched to the
flux cored wire size you are welding.
4.
Misalignment of inlet/outlet guides.
Wire will rub against the misaligned guides and
reduces wire feedability.
5.
Liner blocked with wire debris.
Wire debris is produced by the wire passing through
the feed roller, if excessive pressure is applied to the
pressure roller adjuster.
Wire debris can also be produced by the wire passing
through an incorrect feed roller groove shape or size.
Wire debris is fed into the liner where it accumulates
thus reducing wire feedability.
6.
Incorrect or worn contact tip.
The contact tip transfers the weld current to the
electrode wire. If the hole in the contact tip is to large
then arcing may occur inside the contact tip resulting
in the electrode wire jamming in the contact tip.
When using soft electrode wire such as aluminium it
may become jammed in the contact tip due to
expansion of the wire when heated. A contact tip
designed for soft electrode wires should be used.
7.
Poor work lead contact to work piece.
If the work lead has a poor electrical contact to the
work piece then the connection point will heat up and
result in a reduction of power at the arc.
8.
Bent liner.
This will cause friction between the wire and the liner
thus reducing wire feedability.
