Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 50 of 68
1. Follow all safety precautions and steps in
, page
Backguard and Island Trim Removal
43).
, page
.
NOTE:
It is recommended to remove the door, to prevent weight
or force applied from damaging the door / latch components.
5. Remove all the oven racks.
6. Remove and retain the four T-20 screws and remove the front
cover (see Figure 91).
NOTE:
When reinstalling front cover, it must be positioned with
the cover vents facing to the right (see Figure 91).
Figure 91: Screws Securing Front Cover
7. Remove the nut, and then remove the convection fan. Retain the
shim ring if it falls out when removing the fan (see Figure 90).
Fiberglass
Wear gloves when handling fiberglass insulation.
8. From the back of the range, detach the two convection motor
blade connectors (see Figure 92). Be sure to first make a note of
how they are connected.
NOTE:
It is always recommended to label and tag all wires and
harnesses prior to disconnecting them, so as to correctly identify
their connections/locations when reassembling.
HINT:
Alternatively, you can photograph the wire connections
prior to disconnecting (for example, with your mobile phone).
Figure 92: Convection Motor Wire Connectors
9. Remove the six T-20 screws on the rear cover shield, and pull the
rear cover shield (attached to motor assembly) forward through
the oven cavity to remove it (see Figure 93 and Figure 94).
10. To detach the motor assembly from the bracket, first remove and
retain the shim ring (see Figure 95, page 51).