Thermador Pro Harmony PRL364GDH/01, Руководство по обслуживанию, Страница: 37 / 68

Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 37 of 68
7. Remove clamp (if there is one) by folding the left and right clamp
wings up about 45 degrees (see Figure 60).
8. Pull out the Temperature Selector.
Figure 60: Removing the Clamp
6.3.9 5-Position Oven Function Selector
– Removal and
Replacement
Figure 61: 5-Position Oven Function Selector (Typical Models Shown)
and Knob
NOTE: For PRL364GDH/01, the 5-Position Oven Function Selector
may or may not be secured to the back of the control panel with a
clamp. If a clamped 5-Position Oven Function Selector needs
replacing, the replacement part (used without clamp) is fully
compatible.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 19 .
2. Follow all steps in Accessing Components under the Maintop ,
page 19 .
3. Remove knob from valve stem by slowly pulling knob straight out,
away from control panel.
4. From the front of the control panel, remove and retain the two
screws on the bezel which are attached to the 5-Position Oven
Function Selector (see Figure 62).
5. From the back of the control panel, disconnect the plastic multi-pin
connector from the pins on the 5-Position Oven Function Selector
(see Figure 63).
6. Remove clamp (if there is one) by folding the left and right clamp
wings up about 45 degrees (see Figure 60).
7. Pull out the 5-Position Oven Function Selector.