Thermador C271, Руководство по обслуживанию

Страница: 23 / 84

REMOVING THE BAKE & BROIL ELEMENTS,
CATALYST, & MEAT PROBE JACK
(“C” MODEL OVENS ONLY)
1. Turn off the electrical power to the oven.
2. To make servicing easier, remove the oven
door (see page 2-29).
3. Remove the racks from the oven.
4. To remove the broil element (see Figure
3):
a) Remove the screws from the broil ele-
ment brackets on the rear of the oven
liner, and the screws from the two top
front brackets of the element. Then, re-
move the four screws from the shield,
lower the broil element, and pull it for-
ward.
b) Tie a 12" piece of string around each of
the wire connectors so you can retrieve
the wires if they should slide back inside
the liner.
c) Disconnect the wires from the broil ele-
ment terminals.
d) Connect the wires to the terminals of the
new broil element, remove the string,
and mount the element to the liner with
its mounting screws. NOTE: Do not al-
low the wires to “bunch up” inside the
insulation material when pushing them
into the liner holes.
5.
To remove the catalyst (see Figure 4):
a) Remove the screws and pull it out of the
oven cutout.
b) Install the new catalyst.
6. To remove the meat probe jack (“C” Model
Ovens Only) (see Figure 5):
a) From inside the oven, lift the cover and
remove the hex nut from the meat probe
jack.
b) From outside the oven, remove the screw
from the access panel on the right side
of the oven.
c) Disconnect the two white wires from the
terminals of the meat probe jack.
7. Reassemble the oven.
WARNING
Turn off the electrical power circuit to the
oven at the main junction box before
servicing this unit.
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
CAUTION
Page 21