Thermablaster WDFT060, Инструкция пользователя

Страница: 19 / 34

19
10. CARE AND MAINTENANCE
WARNING: Turn off heater and let cool before servicing
CAUTION: You must keep control areas, burner, and circulating air passageways of the heater clean.
Inspect these areas of heater before each use. Have heater inspected yearly by a qualified service
technician. Heater may need more frequent cleaning due to excessive lint from carpeting, bedding
material, pet hair, etc.
ODS/PILOT AND BURNER
Use a vacuum cleaner, pressurized air, or a small, soft bristled brush to clean.
CLEANING BURNER PILOT AIR INLET HOLE
We recommend that you clean the unit every 2,500 hours of operation or every three months. We also
recommend that you keep the burner tube and pilot assembly clean and free of dust and dirt. To clean
these parts we recommend using compressed air no greater than 30 PSl. Your local computer store,
hardware store, or home center may carry compressed air in a can. You can use a vacuum cleaner in the
blow position. If using compressed air in a can, please
follow the directions on the can. If you don’t follow directions on
the can, you could damage the pilot assembly.
1. Shut off the unit, including the pilot. Allow the unit to cool for at
least thirty minutes.
2. Inspect burner and pilot for dust and dirt.
3. Blow air through the ports/slots and holes in the burner. Also
clean the pilot assembly. A yellow tip on the pilot flame indicates
dust and dirt in the pilot assembly. There is a small pilot air inlet
hole about two inches from where the pilot flame comes out of the pilot assembly (see Figure13. With the
unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air
is not available.
Figure13
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to clean.
Exterior
Use a soft cloth dampened with a mild soap and water mixture.
Wipe the cabinet to remove dust.
1) Use a soft cloth dampened with a mild soap and water mixture.
2) Wipe the cabinet to remove dust.