Thermablaster WDFT060-VF-IR, Руководство пользователя

Страница: 17 / 33

- 17 -
1. Turn the appliance combination control valve button to the “Pilot” position. This should line up with
arrow on the top of the heater.
2. Push down the appliance combination control valve button and keep it depressed for several minutes,
so that all the air in the manifests are cleared out.
3. Keep the combination control valve button depressed and while pushing down the igniter button
thoroughly until ignition can be heard. Both buttons should remain depressed for at least 15 seconds
until the pilot is lit up and the sensor is heated up enough.
4. Release both buttons. If pilot goes out, repeat step 3 and step 4.
5. When the pilot flame is stable, slightly push the gas valve button down and turn to the “6” position
QUICKLY without stopping in between. Heater will then operate normally. Now you can turn the
control button to the position as your desired temperature (approximately 50
O
F to 100
O
F from the
position 1 to 5).
To stop the heater shut off the valve in gas inlet line (not included in delivery scope) first, then turn the
appliance gas valve to “OFF” position.
INSPECTING BURNER
Check pilot flame pattern and burner flame pattern often.
Fig – 11 Fig - 12
PILOT FLAME PATTERN
To ensure quick ignition and efficient ODS function, your heater is uniquely equipped with a supplemental
pilot burner as shown in Fig. 11. The normal ODS pilot flame should have a correct pattern as shown in
Fig. 12 in normal operation with exception during ignition stage.
WARNING: If yellow tipping occurs, your heater could produce increased levels of carbon monoxide.
If burner flame pattern shows yellow tipping, follow instructions at bottom of this page.
Notice: Do not confuse orange flames with yellow tipping. Dirt or other fine particles enter the heater and
burn causing brief patches of orange flame.
LP ODS Pilot Burner Supplemental Pilot burner NAT ODS Pilot Burner