Thermablaster WDFT060-VF-IR, Руководство пользователя

Страница: 12 / 33

- 12 -
Figure 6 - Mounting holes Location
Check Gas Type
Be sure your gas supply is right for your heater. Otherwise, call dealer where you bought the heater from
for proper type heater.
Clearances to Combustibles
Carefully follow the instructions below. This heater is a freestanding unit
designed to be mounted on a wall.
WARNING: Maintain the minimum clearances shown in
Figure 4. If you can, provide greater
clearances from floor, ceiling, and joining wall.
LOCATING HEATER
This heater is designed to be mounted on a wall. For convenience and
efficiency, install heater:
1) where there is easy access for operation, inspection, and service.
2) In the coldest part of room.
MOUNTING HEATER TO WALL
1 . Mounting the Bracket
Mounting the attached bracket with folding anchor on desired location
2. Hang the heater on the bracket
。
8 CONNECTING TO GAS SUPPLY
WARNING: A qualified service technician must connect heater to
gas supply. Follow the heater specification and all local codes. Wrong
gas supply may result improper operation, or damage on your heater, property or/and personal body.
WARNING: This appliance requires a 3/8-inch NPT (National Pipe Thread) inlet connection to the
pressure regulator.
WARNING: Never connect heater to private (non-utility) gas wells. This gas is commonly known as
wellhead gas.
WARNING: Do not over-tighten gas connections.
CAUTION: Use only new, black iron or steel pipe. Internally tinned copper tubing may be used in
certain areas. Check your local codes. Use pipe of 1/2-in. diameter or greater to allow proper gas
volume to heater. If pipe is too small, undue loss of pressure will occur.
Figure 7 Mounting on wall