Therma-tek TC36-6, Руководство пользователя и инструкции по установке

Страница: 3 / 16

INSTALLATION AND SAFETY GUIDELINES
IMPORTANT
Safe and satisfactory operation of your equipment depends on its proper installation. Installation must
conform to local codes, or in the absence of local codes with the National Fuel Code ANSI Z223.1 (latest
edition).
All THERMA-TEK appliances are shipped with a gas pressure regulator packed with the unit. All units are
adjusted, tested, and inspected at the factory prior to shipment.
After uncrating, immediately check the equipment for visible signs of shipping damage. If such damage has
occurred, do not refuse shipment, but contact the shipper and file appropriate freight claims.
GENERAL

Installation of this equipment should be made by licensed and authorized personnel.

A manual gas shut-off valve must be installed in the gas supply (service) line ahead of the appliance
and gas pressure regulator installed in the gas stream for safety and ease of future service.

The gas pressure regulator supplied must be installed on the appliance prior to connecting the
equipment to the gas line. Failure to install a regulator will void the equipment warranty and result in
a potentially hazardous condition.

The appliance and its individual shut off valve must be disconnected from the gas supply system
during any pressure testing of that system in excess of ½ PSI.

The appliance must be isolated from the gas supply system by closing its individual shut off valve
during any pressure testing of the gas supply piping system at test pressure equal to or less than ½ PSI.

Please contact the factory, the factory representative, or a local authorized service company to perform
maintenance and repairs.
RATING PLATE
Information on this plate includes the model and serial number. When communicating with the factory about
a unit or requesting special parts or information, this information is required for proper identification. Other
information on the plate is the BTU/hr input of the burners, gas pressure in inches WC, and whether the unit
has orifices for natural or propane gas.
IMPORTANT: The appliance must be connected only to the type of gas identified on the rating plate.
GAS CONVERSION
We recommend that the appliance be ordered from the factory for the type of gas at the installation site.
When gas conversion is necessary contact the factory for a proper gas conversion kit.
2