7
FOR YOUR SAFETY
1.
Electrical and/or Light Receptacles shall not be installed inside the TheraSauna®
room.
2.
Do not add any locking or latching systems to the door of your TheraSauna®.
Malfunction of which could cause entrapment inside the sauna.
3.
The TheraSauna® comes with a sliding roof vent to provide proper ventilation to
allow in fresh air if so desired. Keep vent closed when heating sauna.
ASSEMBLY TIPS
All assembly instructions are included with your TheraSauna®. The following are
tips for safely and correctly assembling your TheraSauna®:
1.
This sauna will require at least two people to assemble. Panels can weigh up to
100 lbs.
2.
When picking up the side panels or roof, do not pick them up along the thin
trim pieces as they may crack. Also, when putting the walls together, be gentle
and do not push too hard on these trim pieces.
3.
When assembling the walls, do not over tighten the bolts until after you put the
seat panel in place. By leaving the bolts and side panels a little loose, you can
put the bench support panel and seat panel in without scraping the inside walls
of the side panels. Once the seat is in place, you can snugly tighten all bolts.
4.
If you need to move an assembled sauna, you should only push against the
bottom floor section of the TheraSauna®. Do not push against the sidewalls.
5.
Install half-moon light as desired, with glass shade facing up. When considering
your choice for a light bulb for your new TheraSauna®, keep in mind that the
light bulb operates on a dimmer-controlled switch. A standard 60 watt
incandescent bulb is the recommended style or an incandescent bulb that is
designed to be used with a dimmer switch. We do not suggest using a compact
fluorescent bulb as they do not operate correctly with a dimmer and may cause
damage to your sauna’s light control switch. See manufacturer’s warning on
the fluorescent bulb package, “
Not intended for use with electronic timers,
photo cells, or with dimmers.”
Содержание TS4746
Страница 14: ...14...
