QUICK START GUIDE - iw25
5 - TIGHTEN DOGS
Using supplied torx driver bit, tighten all six clamping dogs
until resistance is noticed on the screws and the loudspeak-
er baffle flange is held tightly against the wall surface. This
indicates the dogs have engaged with the back side of the
drywall and that the speaker is clamped successfully.
Figure 5.
FIGURE 6. Set transformer tap switch to select
operating mode.
4 - INSERT SPEAKER
Make sure clamping dogs are fully tucked within the cutout
boundary.
Figure 4a.
Insert speaker into cutout and hold tight against drywall.
Figure 4b.
7 - INSTALL PERFORATED GRILLE
If installing the speaker overhead, insert the grille safety
tether rivet into the speaker frame.
Figure 7a
.
Install the paintable perforated metal grille on the front of
the speaker. High strength magnets will hold it in place.
Figure 7b.
6 - SET 70V / 4-OHM OPERATION SWITCH
For most residential installations, 4-ohm operation is
preferred.
For 4-ohm operation, using a flat-head screwdriver, rotate
the switch to align the triangular indicator mark with the
4-ohms symbol.
For 70V/100V operation, rotate the switch to select the
desired power level to be supplied to the loudspeaker when
the Loudspeaker Controller is set to maximum output. You
may need to wait to set this switch to control the speaker
volume once all the speakers are installed.
FIGURE 4a. Retract all clamping dogs to clear the
cutout boundary.
FIGURE 4b. Insert speaker into cutout and hold
tight against drywall.
PAGE 4
FIGURE 5. Tighten all six clamping dogs to securely
clamp speaker to drywall.
FIGURE 7b. Align indoor grille over the speaker
baffle. Powerful magnets will hold it in place.
FIGURE 7a. Insert grille safety tether rivet into grille
frame as shown. Grille not shown for clarity.
