2-10
Themis Computer
RES-32XEL Installation Guide
2.1.6
Removable Dual-Fan Housing
The RES-32XEL contains four high-speed fans contained in two removable fan
housings (two fans per housing). Both the front and rear dual-fan housings (see
) are removable for replacement in the event of a fan failure.
2.1.6.1 Removal
1.
Make sure the system is powered off (see “Operation” on page 2-16).
2.
Select the dual-fan housing that you want to replace and, with a Phillips
screwdriver, loosen the two captive knurled screws (one at each end) until the
housing is released from the chassis.
3.
Two sets of three wires each form the cabling system of each housing. Care-
fully remove each 3-wire cable from its connector on the motherboard, re-
membering where each cable was attached.
4.
The dual-fan housing can now be removed from the RES-32XEL chassis.
Figure 2-7.
The RES-32XEL Front and Rear Dual-Fan Housings
Knurled Phillips Screw
(2 for each Dual-Fan Housing)
Front Dual-Fan Housing
Rear Dual-Fan Housing
Содержание RES-32XEL
Страница 3: ...iii Themis Computer RES 32XEL Installation Guide VersionRevisionHistory Version 1 0 August 2004...
Страница 4: ...iv Themis Computer RES 32XEL Installation Guide...
Страница 8: ...viii Themis Computer RES 32XEL Installation Guide...
Страница 24: ...1 14 Themis Computer RES 32XEL Installation Guide...