Themis RES-32XEL, Руководство по установке

Страница: 30 / 52

2-6
Themis Computer
RES-32XEL Installation Guide
2.1.3 SCSI Hard-Disk Drive
Perform the following steps to remove and install a hard-disk drive.
2.1.3.1 Removal
1. Make sure the system is powered off (see “Operation” on page 2-16).
2. Locate the drive to be removed (see A in Figure 2-4 ).
3. Place a finger into the latch lock and push to the side; this causes the drive
latch handle to spring forward (see
B ) from the front surface of the drive.
Note: The upper removable disk drive (SCSI ID0) is designated as the boot drive.
Remember that this drive contains the operating system.
Caution: When pulling the hard-disk drive from the chassis, hold it at the
bottom to prevent it from falling and damaging the drive.
Figure 2-4.
RES-32XEL Hard-Disk Drive Removal
Locate the drive to be removed, . . .
A
. . . push the latch lock to the side, . . .
B
Boot Drive
(upper slot)
Latch
Lock
Latch Handle
. . . and pull drive out with the latch handle
C