Themis CoolShell CS-3U, Руководство по установке

Страница: 36 / 118

CoolShell CS-3U Installation Manual
2-4
Themis Computer
3. Connect the keyboard and mouse cables to the USB ports on the right-hand
PCI-Express card or the right of the I/O Blade (see
Figure 2-5 ). These right-
hand USB ports are connected directly to the system motherboard.
Connect the other ends of the keyboard/mouse cables to a keyboard and
mouse, respectively.
4. Install the Storage Expansion Subsystem into the 19” rack above (or below)
the CoolShell CS-3U 3RU subrack.
5. Connect the three cables (Power & Reset, PCI-Express, and Clock/I2C Bus)
from the Storage Expansion Subsystem to the appropriate connectors of the
CPU Blade (see
Figure 2-6 on page 2-5).
6. Connect the power cords to the AC outlets on the power supplies (see Figure
2-7 , page 2-5) and the other ends to an isolated AC wall circuit. This will
cause the CoolShell CS-3U to power on automatically (see following Note ).
Figure 2-5.
Connect the Video Display Cable to One of the Two Middle
DVI Connectors and the KB/M Cable to the Right-Hand USB Connectors
To Video Display To Keyboard & Mouse
Note: Step 4 and Step 5 are applicable only if the optional Storage Expansion
Subsystem is being installed.
Note: There is no master switch for turning power on or off. Instead, the system
becomes active when power cords are connected to the power supplies. Depend-
ing on BIOS settings and the most recent state of the motherboard, it is possible
that the CPU Blade may immediately begin firmware boot followed by OS boot.