Technical data
• Operating voltage (bus): 30 V
• Current consumption (bus): 10 mA
• Permissible ambient
temperature:
–0 °C ... +45 °C
• Protection class:
III in accordance with EN 60730-1
• Protection rating:
IP 20 in accordance with EN 60529
• Mode of operation:
Type 1 in accordance with
EN 60730-1
• Pollution degree:
2 in accordance with EN 60730-1
• Rated impulse with stand voltage: 4 kV
• Bus protocol used:
OpenTherm V4.0 with SmartPower
Service address
Theben AG
Hohenbergstr. 32
72401 Haigerloch
GERMANY
Tel49 (0) 74 74 6 92 0
Fax +49 (0) 74 74/6 92-150
Hotline
Tel49 (0) 74 74 6 92 -369
Fax +49 (0) 74 74/6 92-207
[email protected]
Addresses, telephone numbers etc.
www.theben.de
Minimum heating requirement/screed drying
program
Minimum heating requirement is the preparation for laying
floor coverings and serves to dry the screed to enable fast lay-
ing of floor (= minimum heating requirement). This test must
be performed by the floorer.
• The device supports minimum heating requirement in
accordance with DIN EN 1264-4.
• The minimum heating requirement function is set ex works
and is activated on set-up (LED 1 flashes).
• The function can be deactivated via the ETS (
Minimum
heating parameter)
or reactivated.
• The function can be interrupted up to start-up by
withdrawal of KNX bus module.
Observe deviating technical data on the device rating plate!
Technical changes reserved.
The ETS database is available at
www.theben.de
Please refer to the KNX Handbook for detailed functional
descriptions.
Manual operation – push button test
Press
test
button until heater
switches on.
This test function checks whether the KNX OT box is
correctly connected to the burner.
