23
With a set optimisation of 5 min/K, the thermostat sends the
heating request earlier, as follows:
Set temperature at 06.00 a.m.
23 °C
Actual temperature
17 °C
i.e. Delta T = 6 K
6 K * 5 min/K = 30 min
The controller sends the heating start 30 min. earlier and
reaches the setpoint temperature at 06.00 a.m.
L
The optimisation value depends on the spatial and heating
conditions.
5. Setting the error format
Error notifications from OpenTherm heaters can be received,
depending on the manufacturer, in a hexadecimal or decimal
format (see instructions for the OpenTherm heater).
6. Setting the chimney sweep function
This function is used to carry out the legally required emission
measurements (off, partial load, full load). It is automatically
switched off after 30 min.
7. Setting TSP parameters (Transparent Slave
Parameters)
Depending on the connected OpenTherm heater, various
TSP parameters can be set (see instructions for OpenTherm
heater).
