Raido Equipment
Install and arrange the equipment as shown in the picture.
Solder
Solder
TWM
KP0011310
ESC
Ducted Fan
Front
Battery Cover
Receiver Cover
P.11
9
Completed
Sponge 10x50x150mm
Battery
Battery Tie
Brushless ESC
Receiver
Bottom View
Bottom View
Double - Sided Tape
Please check with your ESC manufacturer if you
can simply connect your ESCs in parallel by Y-cord.
Normally if you are using two identical ESCs, you can
simply connect them in parallel with Y-cord. If you are
not sure, you can disable the BEC in one of the ESCs,
before you connect them with Y-cord. you can do this
by pulling the red wire (the center one) from the 3-pin
plug that goes to the receiver.
ESC-1
ESC-2
FOAM
22x22x60mm
Make sure the heat dissipating surface
of ESC is flush with intake air duct and
expose to air flow.
Intake air duct
Heat dissipating surface of ESC
Pull the red wire
GM046PO256341104
