05/2021 V 1.0
VIEW 23
08/17
Remove Inline Panel Packers and feed
the Underframe Wedge Gasket into the
archway gap of the Return Panel and
Inline Panel and trace along the Glass
on both sides.
Spray water on Glass Panel and use
Nylon Block to help feed Gasket.
Mark the Wedge Gaskets at the edge of
the Inline Panel.
Remove both Wedge Gaskets and trim.
Reinstall Wedge Gaskets after
trimming.
Trim both of the Wall Profile seals at
the top face of each Wall Profile using a
blade.
Check which Stay Bar configuration
your screen has been supplied with and
refer to the relevant instructions below.
(You can find this out at the front of
these instructions).
Config A - SB8
Page 09
29
30
31
32
