The Pool Factory Saltwater Aurora, Руководство по установке

Страница: 37 / 62

Section 2
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING THE POOL BASE
Section
2
No Diving or Jumping. Observe all Safety Rules
A. CONT. INSTALLATION OF BOTTOM PLATES AND BOTTOM RAILS
3. Patio Stones (Recommended)
For Round Section
a. Concrete patio stones may be placed at the base of each
upright of your pool. (Image 4)
b. Each bottom plate will show the location for a patio
stone. Make a mark in the ground at each base plate.
c. Remove the bottom rails and bottom plates and lay out
the patio stones around the circle where the bottom
plates were.
d. The patio stones must be sunk into the ground so
the tops are flush with the soil around them. Use the
carpenter’s level to make sure the patio stones are
perfectly level and flush with the ground. Use either
the carpenter’s level and a 2-by-4 (5cm x 10cm) wood
plank, or the optical level between patio stones to make
sure the stones are level with each other.
(Image 5)
e. Do not install blocks or rails on loose sifted soil or sand.
There must be no space between the ground and the
bottom of the rails. All patio blocks must be flush with the
ground, solid and level with each other in all directions.
NOTE: Installing patio blocks is recommended and the blocks
may shift due to temperature changes.
Important Note:
Make sure the patio stones are perfectly level and flush with
the ground. All patio blocks must be flush with the ground,
solid and level with each other in all directions.
4
5
Page 37