metals or hard materials that cannot be cut form an edge
.
Drill a staring hole larger than
the widest part of the blade.
Battery Pack Operation
To Charge the Battery
1. Contact the charger and charger base
2. Firmly insert battery pack onto charger base
3. Plug the battery charger (adapter) to power source (120V / 60Hz).
4. The Red LED light on the charger base will come on when the unit is plugged in and has power.
5. When the battery is full charged, the Red and Green light will be lighted on.
The proper charging time is 3-5hr.
Unplug charger after charging is complete and whenever it is not in use.
CAUTION:
Only use the provided battery charger for charging the battery. First place the
rechargeable battery into the charging slot in the charger and then connect the charger to the
mains. Charging starts automatically.
Remove the battery from the charge after it’s fully charged (After about 5hrs). Always disconnect
the charger from the mains before you remove the battery from the charger.
The charger and battery may become warm to touch while charging. This is a normal
condition, and does not indicate a problem.
Use the charger at normal room temperatures whenever possible. To prevent overheating,
do not cover the charger and do not charge the battery in direct sunlight or near heat
sources.
If the battery does not charge properly:
1) Check current at power outlet by plugging in a lamp or other appliance.
2) If charging problems persist, have the complete drill checked by an electrician or a power
tool technician.
To Attach Battery Pack
Align the raised portion on the battery pack with the grooves in the handle of saw, and then
insert the battery pack in to the tool as shown in the below image.
Make sure that the latch on the battery pack snaps into place and the battery pack is
secured to the tool before beginning operation.
Working status
Battery
Red
Green
Plug connected into the socket
Not Insert
On
On
Insert
On
Off
Under charging
Insert
On
Off
Fully charged
Insert
On
On
