THE-ONE RS3, Инструкция по эксплуатации

Страница: 47 / 68

POSSIBLE CAUSES PROBLEMS
Wobbling wheel.
Steering not accurate.
Frequent punctures.
Bicycle has reduced range
and/or speed.
Hub motor makes a
“clicking” noise and has
reduce power and/or
shuts off.
No power when the switch
is turned “ON”.
Bicycle operates OK but
battery gauge does not
light up.
Battery gauge lights up but
bicycle does not operate.
Bicycle runs at full speed
without pedaling.
Battery indicates full charge
when tested at the charge
port but bicycle does not
operate.
Bicycle has intermittent
power.
Charge shows a full charge
in an unusually short
amount of time.
Indicator light on charger not
illuminated when charger is
plugged into outlet.
Charger(Lithium) indicator
light only flashes red and
never changes to green.
1. Axle broken.
2. Wheel out of true.
3. Hub comes loose.
4. Headset binding.
5. Hub bearings collapsed.
6. QR mechanism loose.
1. Wheels not aligned in frame.
2. Headset loose or binding.
3. Front forks or frame bent.
1. Inner tube old or faulty.
2. Tire tread/casing worn.
3. Tire unsuited to rim.
4. Tire not checked after previous
puncture.
5. Tire pressure too low.
6. Spoke protruding into rim.
1. Low batteries.
2. Faulty or old batteries.
3. Low tire pressure.
4. Brakes dragging against rim.
5. Riding in hilly terrain, headwind, etc.
1. Low batteries.
2. Damaged planetary gears.
1. Blown fuse.
2. Loose connectors.
3. Broke wire.
4. Faulty switch.
5. Faulty controller.
1. Loose connectors.
2. Damaged wires.
3. Faulty battery gauge.
1. Faulty brake inhibitor.
2. Loose motor wire connector.
1. Faulty sensor.
2. Faulty controller.
1. Faulty controller.
2. Loose connectors.
3. Poor contact between battery
terminals.
1. Loose connectors.
2. Damaged wires.
1. Faulty charger.
2. Faulty batteries.
1. Outlet has no power.
2. Faulty charger.
1. Damage wire from charger port to battery.
2. Faulty batteries.
1. Replace axle.
2. True wheel.
3. Adjust hub bearings.
4. Adjust headset.
5. Replace bearings.
6. Adjust QR mechanism.
1. Align wheels correctly.
2. Adjust/tighten headset.
3. Take bike to a bike shop for
possible frame realigment.
1. Replace inner tube.
2. Replace tire.
3. Replace with correct tire.
4. Remove sharp object embedded
in tire.
5. Correct tire pressure.
6. File down spoke.
1. Charge batteries for recommended time.
2. Replace batteries.
3. Inflate tires to recommended pressure.
4. Adjust brakes and/or rim.
5. Reduced range to be expected in
these types of terrain and/or weather
conditions.
1. Charge batteries for recommended
time.
2. Replace hub motor/wheel.
1. Replace fuse.
2. Check all connectors.
3. Inspect all wires for damage.
4. Replace switch and retest.
5. Replace controller and retest.
1. Check throttle and/or battery
gauge connectors.
2. Inspect all wires.
3. Replace battery gauge.
1. Replace brake inhibitor(s) and retest.
2. Check motor wire connector.
1. Replace sensor and retest.
2. Replace controller and retest.
1. Replace controller.
2. Check all connectors.
3. Inspect and clean battery terminals.
1. Check all connectors.
2. Inspect all wires.
1. Replace charger.
2. Replace batteries.
1. Check outlet for power.
2. Replace charger.
1. Inspect wire.
2. Replace batteries.
SOLUTIONS