5 Net Installation
5.1 Top and Bottom Nets
1. Lay the net on the ground inside the frame, and using the Loops, attach the net to the
frame using two bungees in each corner. - See Figure 4.
2. Next, place two bungees on each of the 4 sides, approximately 12” (30cm) each side of
centre - See Figure 7a.
3. Place a bungee rope in the 5th net space from the corner (both ways) - See Figure 7b.
4. Counting from the bungee rope just installed in the 5th hole, the next bungee rope will
be installed every 4th hole after that. When you install two bungees on one side then go
to the opposite side and do the same, continue this process until the net is fully installed.
See Figure 7c.
5. Repeat Steps 1-4 to install the bottom net.
5.2 Target Net
(Target net is installed between the braces, behind the large rebound net.) With the frame
lying on the sandbags, open target net and lay it on the back of the large rebound net with
the vertical red line facing the top of the rebounder and the targets facing the rebound net.
Using the straps, connect the target net to the eye bolts – after looping through the buckle pull
each strap back until it reaches the eye bolt, do not stretch fully until all 4 corners have been
attached. Once all corners have been attached stretch each strap another 3”- 4” until target
net is tight. (tie loose end of each strap in knots to finish) - see diagram 9.
6
Содержание SKILLMASTER
