The Kick Company SKILLMASTER, Инструкция пользователя

Страница: 5 / 13

4 Frame Assembly
As paint can sometimes leave joints tight you may need to use WD40 (or washing up liquid)
on some joints to ease assembly. - See diagram 1
1. Start with tube marked A connect to tube B and secure with bolt - hand tighten only
(Head of bolt to front of frame, washer to inside of frame.) Continue this process with
tubes C (x 2), (Note: where tube C connects to tubes A & B do not insert bolts as
these will be secured when brace is installed ) continue with D (x 2), E, F, G & H. - See
diagram 2. At this stage you can tighten all bolts that have been installed so far. (Note:
do not over tighten bolts).
2. Continue with tube I x 2 and secure with bolts – hand tighten only, see Figure 3b
3. Using the sandbags filled earlier lay them on the ground in line with uprights two on each
side approx. 4/5ft apart and approx. 3ft from front of frame. - See diagram 3. Lie frame
down on sandbags and continue assembly with tubes J x 2. Continue with tubes K & L
and secure with bolts – hand tighten only. See diagram 4. ( Note: where tubes I & J
connect do not insert bolts as these will be secured later when brace is installed.)
4. Connect tube M(x2) to tube N(x2) using Eye bolts.- making sure the eye of the bolt is
facing away from the angle on tube M – see diagram 4.
With the frame still lying on the sandbags connect tube M to I & J and tube N to B &
C on one side. Repeat process on opposite side - See diagram 4.
5. You can now tighten all bolts (Be careful no to over tighten).
6. Install Eye bolts (x 2) into holes at the top of the frame in tubes K & L making sure the
eye of the bolts are facing the back of the frame (towards braces) - See diagram 4.
5