STEP 6
•
Attach the Handle Shaft
(26)
between the top ends of the Wheel Assembly Frames
(20).
Pass two M6x45
Bolts
(11)
through the Wheel Assembly Frames & Handle Shaft. Install the Pivot & Bracket Assembly
(19)
onto the protruding bolt ends. Fasten with M6 Lock Nuts
(24).
•
Ensure the Pivot & Bracket Assembly is on the right-hand side when standing behind the spreader.
NOW GO BACK AND TIGHTEN ALL THE NUTS AND BOLTS, STARTING AT STEP 1. DO NOT OVER TIGHTEN.
NOTE: The handle can be higher or lower depending on the user’s preference. Before installing the gauge,
upper handles and handle shaft, decide which of the three positions will be most comfortable for the
operator. If the middle or upper positions are chosen, use a handle spacer in the hole nearest to the handle
grips.
