ADDING FUEL
Fill the fuel tank as instructed in the separate Engine Manual packed with the machine.
Fill the tank to no more than 12.5mm (1/2”) below the bottom of the filler neck to allow space for
expansion.
CAUTION
Engine Oil has been drained for shipping.
Failure to fill the engine sump with oil before starting the engine will result in permanent damage and will
void the engine manufacturers warranty.
ADD OIL ACCORDING TO THE ENGINE MANUFACTURERS ENGINE MANUAL, PACKED SEPERATELY WITH YOUR
MACHINE.
OPERATION
•
Never park the machine in a place with unstable ground which could give way, particularly when the dump
box is full.
•
Disengage the clutch lever before starting the engine.
•
Start the engine carefully according to the instructions and with your feet well away from the moving parts.
•
Never leave the operating position when the engine is running.
•
Always hold the unit with both hands when operating. Keep a firm grip on the handlebars. Be aware
that the machine may unexpectedly bounce upward or jump forward if the machine should strike buried
obstacles such as large stones.
•
Walk, never run with the machine.
•
Do not load the machine over its capacity. Drive at a safe speed, adjusting the speed to the slope of the
land, the surface conditions of the road, and the weight of the load.
•
Use extreme caution when in reverse or pulling the machine towards you.
•
Exercise extreme caution when operating on or crossing gravel drives, walks, or roads. Stay alert for
hidden hazards or traffic.
•
On soft ground, drive at the first forward/reverse gear. Do not rapidly accelerate, turn sharply or stop.
•
Pay the utmost attention when working on frozen ground as the machine may tend to skid.
•
If possible, avoid driving on pebbly river beds, crushed stone terrains, steel, concrete, stumpy field,
logs etc., since such operation will cause fatal damage or shorten the life span of the tracks.
•
Do not operate the machine in confined areas where there may be a risk of crushing the operator between
the machine and another object.
•
Never operate the machine on slopes where the angle is over 20° degrees.
•
When moving over a slope, whether moving forward or in reverse, always make certain that the weight is
evenly balanced. Always move in directions parallel with the slope. To
•
avoid danger, do not shift gears on slopes.
•
When tipping the load from the dumper, the centre of gravity will change continuously and the stability of
the machine will vary depending on the conditions of the ground beneath it. There are special hazards for
dumpers working on soft ground and when the load is sticking to the machine e.g. wet clay.
STARTING THE ENGINE
A more detailed description of the engine operation and all related precautions and procedures can be found
in the Engine Manual packed separately with the Mini Transporter.
Follow the procedure below for cold starts:
1.
Turn choke lever on the engine to full choke position.
2.
Set the throttle lever on the handlebar at halfway position.
3.
Turn the engine switch on.
4.
Pull the starting rope slowly several times to allow the gasoline to flow into the engine’s carburettor. Then
hold the start handle firmly and pull rope out a short distance until you feel some resistance. Then pull the
rope smoothly and briskly and allow rope to return gently. Do not let the rope snap back. If necessary, pull
the rope several times until the engine starts.
5.
Allow the engine to run for several seconds to warm up. Then, gradually move chock lever to “OPEN”
position.
Содержание THLC09715
Страница 21: ...PARTS LIST THLC09715 193844003 ...
Страница 25: ...NOTES ...
Страница 26: ...NOTES ...
Страница 27: ......