Slide the Large Washer over the Front Axle
Support protruding leg (this is stepped) and
slide the Split Pin through the hole. Split open
the Pin legs to secure.
STEP 8
Attach the Pull Adapter (13) to the Yoke by
aligning the holes in the handle, handle
coupling and the Yoke.
Secure using the Pull Handle Bolt, Washer and
Nut (21).
If you wish to attach the trolley to a garden
tractor, remove the end of the Pull Handle by
undoing the R-Clip and removing the Pull Bolt,
and attach the tow hitch directly to the
tractor using the same R-Clip & Pull Bolt.
STEP 9
Slide the Wheel onto the axle.
Secure using a Wheel Washer and a Wheel
Nut on to the axle.
Do not over tighten; this may cause the wheel
to not rotate. Repeat with the remaining
wheels.
STEP 10
Turn the Trolley over onto it’s wheels (DO
NOT try and lift on your own, ask for
assistance!)
STEP 11
Attach the two Side, Front & Rear Panels to
the Bed, using the R-Clip (Two for each Panel).
