UNPACKING AND SET-UP
1. Open carton, then remove ramp and shipping boards.
2. Connect foot-operated air valve to 110 psi maximum air supply. The lift may be damaged
and/or personal injury may result if the pressure exceeds the maximum 110 psi rating.
3. Stand clear of lift table, and depress the UP side of foot valve to raise table.
4. To lower table, lift detent bar from safety latch and lower to next position or to floor.
5. Mount ramp to top by inserting ramp tabs into slots in lift top.
OPERATION
1. Loads must be centered on table at all times. Table is rated for a maximum load of 1500 lbs.
2. Loads must be firmly positioned and secured on table at all times. Tie-down straps must be used
in conjunction with the holes provided in the lift top.
3. All moving parts have been lubricated at the factory and should be re-lubricated every (6)
months to prevent galling. Grease zerks are located at each end of frame pivot shaft and at
top ends of inside frame assembly.
4. Lightly oil cylinder rod when it becomes dry.
5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every
(6) months.
6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top end of the inside frame assembly.
OTHER OPTIONS AVAILABLE
Separate installation instructions included with each option.
PART#
DESC RIPTION
14476
C V-17 C YC LE VISE
- Used to sta b lize m otorc yc les while on lift.
14473
12” SIDE EXTENSION
( 2) -
Exp a nd s wid th of lift from 28” to 52” inc lud es sta b ilizer b a r.
14474
13” FRONT EXTENSION
-
Extend s lift top to 97” for long er wheel b a se m otorc yc les.
14475
TRIKE EXTENSION
- Used for 3 wheeled vehic les.
21300
SPYDER/ TRIKE EXTENSION
– For Sp yd er Trikes a nd 3 wheeled vehic les.
21660
DEC K HAND -
Used to lift the front end of yo ur resid entia l a nd c om m erc ia l m owers
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS.
DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS
ARE FOLLOWED CAREFULLY.
Содержание 16013G
Страница 3: ...PARTS DRAWING PARTS LIST ...
Страница 5: ......