The Handy 10740, Инструкция по эксплуатации и перечень запасных частей

Страница: 6 / 9

STANDARD ELECTRIC LIFT
NOTE: THIS SYMBOL MEANS WARING OR CAUSTION: DEATH, PERSONAL INJURY
AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED
CAREFULLY. READ ENTIRE
POWER SUPPLY
This lift is for operation on 115 volt, 60 Hz current only. Check outlet voltage before plugging in equipment.
WARNING: This lift is equipped with a 3-prong plug which must be plugged into a grounded
115 volt, 60 Hz power supply for your safety. Removing ground prong from plug or failure to plug
into a grounded receptacle may result in a fatal electric shock.
UNPACKING AND SET-UP
1. Open carton, then remove ramp and shipping boards.
2. Keeping hands free of lift mechanisms to avoid personal injury-CAREFULLY turn left over.
3. Mount ramp to lift top by inserting ramp tabs into slots on lift top.
NOTE: If cycle vise is being installed, ramp must be mounted opposite the cycle vise.
OPERATION-LUBRICATION
1. Loads must be centered on table at all times.
2. Loads must be firmly positioned on table at all times.
3. All moving parts have been lubricated at the factory and should be re-lubricated occasionally to pre
vent galling. Grease zerks are located at each end of frame pivot shaft and at top ends of inside frame
assembly.
4. The drive screw, motor and gear box were factory lubricated, and this lubrication should last for the life
of the lift. Should re-lubrication be necessary, use a No. 9 multi-purpose gear oil in gear box and an “O”
grade gear grease on drive screw.
5. Frame/motor pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top of the inside frame.
INSTALLING
The drive train components have been burnished in to give a tight, well working fit and will be stiff for the
first few cycles. If drive screw should seize, put a few drops of oil on screw and reverse a few times. If
motor should pull down or hum, TURN OFF IMMEDIATELY. Check to see if drive screw is free.
Other Options
Available
Separate installation
instructions included
with each option
PART # DESCRIPTION
14476
CV-17 CYCLE VISE – Vise with removable wheel stop built into vise
10728
12” SIDE EXTENSIONS (2) – Expands width of lift from 24” to 48” includes stabilizer bar
16011
13” FRONT EXTENSION – Extends lift top to 93” for longer wheel base motorcycles
10736
13” REAR EXTENSION – Extends lift top to 93” for longer wheel base motorcycles
15566
RAMP END EXTENSIONS – Attaches to end of lift ramp for a more gradual incline to
prevent bigger bikes from dragging bottom.
10737 SNOWMOBILE WING KIT – Used when lifting snowmobiles
10732 LIFT DOLLY – Helps move lift while in down position
16010 TOOL TRAY – Keeps tools organized and Handy