5
Step 5
Fit the long plastic profile with insulation into the groove on the door frame and
press it into place so that the lip lies against the side wall on both sides. (Fig. 5).
Step 4
Select the hinge
side on the door by
turning the door
frame with the door.
Place the door with the
frame into the opening to
ensure that it fits.
Remove it again and apply
a thick strip of sealant
(cartridge supplied) in the
opening approximately 1cm from
the edge and internally around the
entire door opening.
Insert the door frame with the door and screw
the door frame securely to the ceiling on the upper side.
Seal around the whole frame from the inside,
make sure that it is tight. (Fig. 4).
Step 6
Remove the packaging from the compressor unit and pull
out the power cord.
Lift the unit into the opening, and at the same time pass
the power cord up between the cover on the back.
Carefully screw the unit securely at each corner so that
the gasket on the flange is pressed neatly against the
element wall.
NOTE: Secure the power cord over the ceiling with the
clips supplied, to prevent it from falling into the noise
channel and damaging the fan. (Fig. 6).
Fig. 4
Fig. 5
Fig. 6
