19
cab - Produkttechnik GmbH / Tharo Systems, Inc.
Loading Labels
1. Raise the printhead by rotating the printhead lever (
1
) clockwise until it stops.
2. Loosen the media retainer knurled screw (
5
) and swing the media retainer (
3
)
upwards.
3. Place the roll of label stock (
2
) onto the media supply hub (
4
).
4. Swing the media retainer (
3
) downward and inward until it rests on the media
supply hub (
4
), against the side of the label roll.
Retighten the knurled screw (
5
) .
5. Slide the media guide (
6
) outward, allowing enough clearance for the label
stock's width when loaded.
6. Unroll a length of label stock from the media roll. From the side, slide the
media under the media assist bar and inside the media guide (
6
) as shown in
Figure 6a. It is particularly important to ensure that the media strip slides
correctly under the arm of the photocell assembly (
7
).
2 3
4
5
1
7
6
Figure 6 a Media Loading - Part 1
