U S E R ’ S G U I D E
6
U S E R ’ S G U I D E
5
After opening the rear cover, take out the air flow chamber with
foam filter, by pulling it up. Refer to the figure.
Place the air flow chamber back into the machine once water
tank has been filled with water.
Make sure that the air flow chamber is sitting in the machine
properly.
Caution: To avoid breaking of rear cover, please follow
instructions below while opening and closing.
Clip in the rear cover into main unit as per attached picture.
Add about 17 ounces (0.5 liters) of water to Water Level Line, which is the
lower line marked on the water tank, refer to the figure.
Wa rning: Do not operate H2O Va c
®
Tu r b o
T M
without water in the water tank.
This vacuum cleaner uses advanced water filtration technology so that dirt and
dust are forced through a pool of water and trapped in the water.
Without water all the dirt will accumulate on the foam filter located inside the
a i rflow chamber and the suction power will be significantly aff e c t e d .
Never fill the water above the “Water Level Line” before vacuuming.
The “Maximum Dirt Level” takes into account the combination of the initial water
fill, plus all accumulated dirt, dust and small wet spills during a normal
vacuuming session. Check the accumulation of dirt inside the water tank
occasionally during vacuuming to avoid exceeding the “Maximum Dirt Level”
line marked on the tank.
Startup and Speed Control
Plug in the power cord, and press the power switch to startup the
machine.
IMPORTANT: Do not pull out the power cord past the
red tape mark.
Press the speed switch on the big handle to
control the speed. There are 4 different speeds.
Attach the telescopic (extension) handle to the curved tube at
the end of the flexible hose and make sure they are firmly
secured.
Press the control button to adjust the length of the telescopic
(extension) handle. The telescopic (extension) handle will
automatically lock in place once the button is released.
Attach the standard head attachments as needed to the
telescopic (extension) handle.
Open the rear cover according to the directions indicated in the
figure.
Operating Instructions
Close the rear cover and gently push it down to secure it in place.
Do not hit or force the cover to close. Applying extra pressure can
break the rear cover.
Plug flexible hose into vacuum.
Suction Power Control on the Handle
To control the suction power, adjust the button on the curved tube.
CLOSED for full suction power. OPEN to reduce the suction power
and to stop large objects from getting stuck in the tube.
You can also adjust the suction power by pressing the speed switch.
For more suction power select higher speed and vice versa.
MAX Dirt
Level
Water
Level
FAILURE TO FOLLOW THESE WARNINGS MAY CAUSE DAMAGE TO THE ELECTRICAL PA RTS OF
THE VACUUM AND/OR THE SURFACE OF YOUR FLOOR AND WILL VOID ANY WARRANTIES ON
THE PRODUCT.
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN ELECTRICAL SHOCK, FIRE,
DAMAGE TO THE PROPERTY OR SERIOUS PERSONAL INJURY AND EVEN DEATH.