Seite 7 / 8
6) Setting and Adjusting Speed
The two push-buttons at the front, labelled with “33” and “45” are to be used to start and
stop the platter on the speed indicated. The push-buttons do have an integrated light, show-
ing the actual status of the turntable:
-
Blinking single light: acceleration phase of the platter
-
Steady: Platter turns on the speed indicated
-
Blinking both lights: Battery needs to be charged. As soon blinking of both lamps
starts, the battery will rest for at least one hour in playback mode.
The speed of the turntable was set in our factory using most precise equipment. This setting is
stable for a long time period. If re-adjusting is needed, use the specific adjusting-key (1) deliv-
ered with the TTT-C.
The adjusting-key is set thru the hole at the front of the TTT-C and connected to the internal
potentiometer. Turning the key clockwise will decrease; turning it anticlockwise will increase
the speed of the platter.
7) Clamp
The TTT-C is delivered with a record-clamp designed for this turntable specifically. This clamp
is working harmonically with the high density inlay of the main platter. It reduces vibration
and deformation of the record itself and ensures steady contact between platter and record.
Please plug the clamp carefully on the spindle of the turntable. The clamp is not screwed or
tightened, but operates with its mass only.
8) Cleaning
For cleaning the TTT-C, please use a soft and clean towel. The high density inlays of the platter
and the clamp shall be cleaned with a wet microfiber towel. For this process, please use water
only, neither cleaning nor dissolver-liquids.
33
45
2
1
