Thales MissionLINK Certus 200, Руководство по установке

Страница: 34 / 61

2-9
Installation Guide 84465 Rev. H
5. Assemble screws (1) with flat washers (3) and split lock washers (2) as shown in Figure
2-2 and torque to requirements.
6. Connect coaxial cable as shown in Figure 2-3 and hand tighten.
7. After connecting the cable to the antenna (Figure 2-3), wrap the connector with self-
vulcanizing tape to ensure a water-tight seal.
8. Run coaxial cable to the TU installation location.
Installation of the Certus 200 Broadband Active ANTENNA (BAA)
Magnetic Mounts
The Base kit available for the Certus 200 MissionLINK system does not include magnetic
mounts, but these can be ordered as an accessory for convenient quick mounting of the antenna.
Certus 200 Magnetic Mount kit is 1100856-501 and contains 3 magnets and mounting hardware.
1. Assemble magnets with M4 standoffs to antenna at the three mounting points as shown in
Figure 2-4 and hand tighten.
NOTE
Do Not tool tighten or torque the mounts. Doing so could cause
damage to the unit.
2. Place Antenna in desired final operating location on ferrous surface with all three
magnets in contact with surface. Failure to make contact with all three magnets may
cause loss of mount integrity.
3. Connect coaxial cable and hand tighten.
4. After connecting the cable to the antenna, wrap the connector with self-vulcanizing tape
to ensure a water-tight seal.
5. Run coaxial cable to the TU installation location.
Pole Mount
An accessory mounting bracket kit is available for fixed mount applications of the Certus 200
MissionLINK antenna. This Premium L-Bracket kit is 1100855-503 and has the holes that match
the locations where the magnetic mounts attach. The bracket kit does not come with M4 screws
so those must be purchased by the installer. The holes accommodate an M4 stainless screw that
is 5 – 7mm in length (a bit longer if you are using washers and/or lock washers). Max depth with
plate and screw insert is 7.5mm. Bracket details are below in Figure 2-4.