Thales MissionLINK Certus 200, Руководство по установке

Страница: 26 / 61

2-1
Installation Guide 84465 Rev. H
INSTALLATION
General Guidelines
General Guidelines for Installation

Do not attempt to service items such as TU and BAA.

Do not alter or remove tamper seals/tape from the equipment.

Always use Ground Lugs as separate connections to chassis and antenna.

Always torque hardware to specified values.

Always keep the MissionLINK antenna away from other radiating antennas that may
interfere with it.
Tools and Supplies Needed for Installation
List of tools you may need to install this system:

Drill and drill bits

Pliers or wrench

4mm Hex Drive Wrench

Torque Wrench

Allen Head Kit – Insert Bit Kit Z-MC7

Marker or pencil

Tie wraps

Self-vulcanizing tape to seal connections
Preparation
Prepare the MissionLINK Installation Kit as follows:
1. Unpack and lay out all components and parts.
2. Inspect for any damage
3. Conduct an inventory of all components and parts using the equipment packing list
provided with the equipment. Any missing items and/or shipping damage should be
reported immediately to Thales Customer Service Department (Tel: (800) 324-6089 or
email
customer.service@thalesdsi.com ).