Thales Affinity LBD-200C-N1, Руководство по эксплуатации продукта

Страница: 18 / 60

Specifications - 12 -
®
Affinity LBD-200C-N1 Transmitter
Product Manual
5 Specifications
5.1 Affinity® LBD-200C-N1 Transmitter Specifications
Parameter Specification Test Conditions/ Notes
Transmitter Output
Average Output Power at the
transmitter output (using RF probe
to sample main output; N-
connector)
54.5 dBm in application with channel
filter
1. Thermal power sensor is
recommended to verify average
output power.
2. Modulated carrier
3.
UHF input frequency 670 – 675
MHz
4. UHF input power –18dBm ±3dB
5. UHF input waveform COFDM
DVB-H
6. ALC – ON, AGC – ON
7. Linearization – ON
Average Output Power at the
channel filter output (using RF
probe to sample main output; N-
connector)
53 dBm assuming 1.5 dB insertion loss
of the circulator, channel filter, RF
probes and jumper cables
1. Thermal power sensor is
recommended to verify average
output power.
2. Modulated carrier
3.
UHF input frequency 670 – 675
MHz
4. UHF input power –18dBm ±3dB
5. UHF input waveform COFDM
DVB-H
6. ALC – ON, AGC – ON
7. Linearization – ON
Out of band Intermodulation
Products / Adjacent Channel
Interference
FCC spectral mask definition for the
1670-1675MHz band per FCC
Document 47, Telecommunications:
Part 27, Miscellaneous Wireless
Communications Services:
Section 53, Emissions Limits. Subparts
(i), (a) (4)
Sidelobe power spectral density (PSD)
across 1MHz shall be attenuated below
the TX (PSD) power (P) by 43+10log
(P)
Spectral Mask must be measured at
the output of the channel filter.
TX input has to exceed FCC spectral
mask definition if OEM exciter is used.
For TX compliance shoulder level
typically should be better than 50dB at
breakpoint w/ minimum of 8db non-
linear correction capability.
1.
Thermal power sensor is
recommended to verify average
output power. Emissions
measured with spectrum analyzer
or VSA RBW=30kHz VBW=
100Hz
2. Modulated carrier
3.
UHF input frequency 670 – 675