PS-7900 Series User Manual
37
To customize PTZ patrols:
1.
Enter the PTZ Configuration menu, shown in Figure 42 by going to Main Menu > System Configuration > PTZ
Configuration.
2.
Select the
On Camera Settings
tab.
3.
Select a
Patrol Number
to set from the drop down list.
4.
Select a
Preset Number
that is next to the
Patrol Number
from the drop down list that you would like to add to the
patrol.
5.
Click the Add button. The
Preset Number
will be added to the patrol list.
6.
Repeat steps 4-5 until you have included all the presets you would like to have on the patrol.
7.
Click the Up and Down button at the bottom of the list to change the order of the presets in the patrol.
8.
To test out your new preset, click the Play button. The PTZ should move through the list of added presets.
9.
Click the Done button to exit out of the PTZ Configuration menu.
6.5 Configuring Alarms and Exceptions
6.5.1 Setting Up Motion Detection
Set up properly, using motion detected recording will increase the number of days your DVR is able to record. It will only record
relevant events rather than everything, which will also make searching for events easier.
To set up motion detection:
1.
Enter the Motion Detection Settings menu, shown in Figure 45 by going to Main Menu > Recording Configuration > Motion
Detection Settings.
Figure 45. Motion Detection Settings Menu
2.
Select the camera to configure in the camera drop down menu on the upper left of the menu. If all cameras are to be configured
with the same settings, select
All Cameras
from the list
.
3.
Check the
Enable Motion Detection
checkbox to enable motion detection for the selected camera. Uncheck the checkbox to
disable motion detection.
4.
Set the motion detection sensitivity by adjusting the green
Sensitivity
bar. The more lime green rectangles selected in the bar,
the higher the sensitivity will be to motion.
5.
Set the motion detection region in the preview screen on the right side of the menu by left-clicking with the mouse on an open
area. A red grid will be shown, designating that the selected area is part of the motion detection region. Dragging or left-clicking
on areas that overlap the current selected motion detection area will include them into the region. You may also click the Full
Screen button to include the whole area into the motion detection region. Left-clicking on any part of the grid will remove that
section from the motion detection region.
6.
If you‟re not satisfied with the selected region, you may click the Clear button to reset the motion detection area.