18
Table 2: Scooter Controller Internal diagnostics
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code flashes from the diagnostic light in the event one of the conditions listed below
develops.
Number of
Flashes
Possible
Solution
1
The battery needs charging or there is a bad
connection to the battery.
Check the connections to the battery. If the
connections are good, try charging the battery.
2
There is a bad connection to the motor.
Check all connections between the motor and the
controller.
3
The motor has a short circuit to a battery
connection.
Please contact your Authorized Service Center.
4
Not available
5
Not available
6
The controller is being inhibited from driving.
Check the battery charger connector.
Remove the battery charger from the scooter.
7
A speed control lever fault is indicated.
Make sure that the speed control lever is in the
rest position before switching on the scooter.
8
A controller fault is indicated.
Make sure that all connections are secure.
9
The parking brake has a bad connection.
Check the parking brake and motor connections.
Make sure the controller connections are secure.
10
Excessive voltage has been applied to the
controller.
Check the battery connections. This is usually
caused by a poor battery connection.
If you are in any doubt about carrying out any of the previous suggestions please contact your dealer or
TGA.