©Copyright Task Force Tips LLC 2007-2021
3
LIY-410 May 28, 2021 Rev06
NOTICE
• Do not pinch any wires between the lid and box.
• Ensure rubber O-ring seal for lid is clean, undamaged, and properly placed in the groove prior to
securing the lid.
STEP 7
Connect the radio board to the
communication board by aligning pin
holes and pushing firmly.
STEP 8
Attach the antenna connector to the radio
board in the orientation shown.
• In some cases, a cable tie may need
to be cut to attach the antenna.
STEP 9
Reinstall the communication/radio board
assembly into the monitor control box.
Press straight in to seat firmly.
1
2
3
4
STEP 10
Plug the connector with the blue & white
wires into the communication/radio board
assembly.
Route antenna wire alongside the board.
STEP 11
Replace the lid. Be sure to guide the flat
cable across the motor boards.
STEP 12
Firmly tighten screws equally in a criss-
cross pattern.
