©Copyright Task Force Tips LLC 2004-2020
5
LIX-300 October 23, 2020 Rev22
3.2 ELECTRICAL SPECIFICATIONS
Table 3.2
3.3 OPERATING ENVELOPE
Nozzle A flows 500 gpm (1900 l/min), at 100 psi (7 bar), K factor = 50
Nozzle B flows 750 gpm (2800 l/min), at 100 PSI (7 bar), K factor = 75
Nozzle C flows 1000 gpm (3800 l/min), at 100 PSI (7 bar), K factor = 100
Nozzle D flows 1250 gpm (4700 l/min), at 100 PSI (7 bar), K factor = 125
Figure 3.3
3.4 USE WITH SALT WATER
Use with salt water is permissible provided the equipment is thoroughly cleaned with fresh water after each use. The service life of the
equipment may be shortened due to the effects of corrosion, and is not covered under warranty.
To reduce galvanic corrosion, it is highly suggested to use galvanic isolator kits between the monitor & mounting flange. Order Part # Z-
G4A150 (4") or Z-G3A150 (3"). For additional protection with 4 inch flanges, we also offer a secondary extended isolator to use in
conjunction with the standard isolation gasket kit. Order Part # Z-FIS4A150S
Nominal Operating Voltage
12 or 24 VDC (auto sense)
Minimum Voltage
12 VOLT System 10 VDC at the monitor
24 VOLT System 18 VDC at the monitor
Maximum Voltage
32 VDC
Maximum Torque (Elevation)
60 ft·lbs (80 N·m)
Maximum Torque (Horizontal)
60 ft·lbs (80 N·m)
Speed (Elevation)
9 deg/sec
Speed (Horizontal)
12 deg/sec
WARNING
Damage or injury could result from operating the monitor beyond the safe operating envelope. Do
not operate the monitor outside the envelope in the following graph(s).
NOTICE
If equipped with a TFT Corrosion Isolation Sleeve, the use of a gasket on either side of the sleeve is
required. Do not use a TFT Corrosion Isolation Sleeve as a gasket replacement.
0
25
50
75
100
125
150
175
200
225
250
0
200
400
600
800
1000
1200
1400
0
4
8
12
16
0
1000
2000
3000
4000
5000
Monitor Loss
Nozzle C
Inlet Pressure
Nozzle B Inlet
Pressure
Nozzle D
Inlet Pressure
Nozzle A Inlet
Pressure
Hurricane Operating Envelope
Flow (gpm)
Monito
r Inlet Pressure (psi)
Flow (lpm)
Monitor Inlet Pressure (bar)
Maximum Nozzle
Inlet Pressure
Maximum Monitor
Inlet Pressure
