©Copyright Task Force Tips LLC 2004-2020
18
LIX-300 October 23, 2020 Rev22
4.5 HORIZONTAL ROTATION TRAVEL STOPS
The range of horizontal rotation travel for the manual Hurricane monitor is continuous 360 degrees. The motorized version is limited to
450 degrees, or 225 degrees from either side of a straight ahead position. Horizontal (left-right) travel stop bolts may be installed in the
monitor to limit travel. Note that left and right are relative to the “Straight Back Reference Mark” and refer to the operator’s position
behind the monitor, opposite the nozzle’s discharge direction. Figure 4.5A and Figure 4.5B show the range of travel for the various stop
bolt locations along with installation notes.
The range of horizontal (left-right) travel for the Hurricane RC monitor is limited to 450 degrees, or 225 degrees from either side of a straight ahead position. Horizontal (left-right) travel stop bolts may be installed in the monitor to limit travel. Note that left and right are relative to the “Straight Back Reference Mark” and refer to the operator’s position behind the monitor, opposite the nozzle’s discharge direction. show the range of travel for the various stop bolt locations along with installation notes.
Figure 4.5A
Figure 4.5B
LOCATION OF
STRAIGHT BACK
REFERENCE MARK
45°
LEFT
45°
RIGHT
135°
RIGHT
90°
RIGHT
225°
LEFT
225°
RIGHT
135°
LEFT
90°
LEFT
90° LEFT
135° LEFT AND RIGHT
(ONLY ONE STOP BOLT
NEEDED FOR THIS
TRAVEL LIMIT)
45° LEFT
STRAIGHT BACK
REFERENCE MARK
90° RIGHT
45° RIGHT
ADJUSTMENT DISK, Y3146
INSTALL ON THIS SIDE OF STOP BOLT TO
REDUCE TRAVEL TO LEFT BY APPROX. 8°
FOR EACH DISK INSTALLED. INSTALL DISKS
ON OTHER SIDE TO REDUCE TRAVEL TO RIGHT.
SET SCREW
#VT37-24SS375
To change the Horizontal Rotational Travel Limits:
1. Remove the Set Screw
2. Insert 1 Adjustment Disc (Not included. Contact tft.com for parts)
in the bolt hole for every 10° of travel limitation
3. Replace the Set Screw with the Stop Bolt
STOP BOLT
